Common household drinking glitches and solutions!

Date：2014/3/14 10:30:02

 Each dispenser can be said that the current drinking water essential household appliances inside. Of course, we inevitably will occur when using the dispenser of some glitches, then what causes it, how can we solve these problems? 

  

Common faults are: heating lamp does not light, not heat. In other words, the installation of water. 

  

Internal machine without water dry off. Remedy is: cut the power under the premise of open board, there are two thermostat on the hot water side of bile, which is temperature-controlled with an anti-dry switch, using a screwdriver to push the switch that available; After a reset switch, power check, re-heating indicator light, turn the power off, screw on the rear panel; 

  

Light does not heating, how to reset the thermostat reset? 

  

96% of the drinking fountains in use manual reset thermostat as hot tank overheating protection, the failure of the thermostat, hot water tank temperature is too high or dry, the manual reset is only action, cut off the power supply, since to protection. After the take-off does not automatically reset the thermostat must be reset manually before. Reset methods are: (1), unplug the power cord, turn off the power; (2), wait for hot water tank is reduced to below 25%, press the reset button on the thermostat. 

  

Drinking leakage: 

  

Check the power cord for damage, cracks, exposed wires, if repaired or replaced. 

  

Check that the power outlet is grounded? Otherwise well grounded, mainly because of poor ground dispenser. 

  

Remedy: You must use grounded three-prong outlet and install leakage protection, and promptly eliminate leakage fault. Please specialized personnel or check ground resistance with megger. 

  

Drinking indicator anomalies 

  

Symptom repair method causes a red light does not shine, finishing loose connector or replace the connector 2, the protection is not reset thermostat manual reset 3, replace burned out light-emitting diode light-emitting diode 4, replacing the current limiting resistor burned limiting a green light resistance, transformer input fuse replacement fuse burned 2, replace burned out light-emitting diode light-emitting diode 3, replacing the current limiting resistor burned limiting resistor 4, finishing loose connector or replace the connector 5, the water temperature below 5 �� immortal a non-fault the green light, the fan is damaged replace the fan 2, coolers or replace the cooling effect of poor finishing film 3, the ambient temperature is too high, can not achieve the status of a non-thermal conversion failure 4, replace damaged thermistor thermistor or coolers 

  

Drinking cold water temperature series 

  

Reasons (1): the base level is full of hot water over the vent. 

  

Remedy: Check the water filter installed float valve is no good. Water dispenser water is full of bile within the gall up and over the side of the hot water dispenser holes. Connectivity with hot and cold water temperature caused by the string. 

  

Solution: Re-install the float valve can be. 

  

The reason (2): the machine into the hot seat on the bile duct connection "check valve" fault, hot water storage bile reflux back, communicating with hot and cold water temperature caused by the string. 

  

Solution: Replace the "check valve"